Carrier Access Network Device Axxius 800 Manuel d'utilisateur télécharger pdf (Page 16)

18 Axxius 800 - Release 2.2

Quick Start

Chassis Connections

5. Ensure that no bare wire shows after the wires are installed.

6. Plug connector in the INPUT (power) connector, as seen in the graphic and

secure with set screws.

7. Apply power to connector.

8. Verify with voltmeter that voltage is correct and polarity is correct.

9. Plug connector(s) into the Axxius 800.

10. A green light should appear on the DC Input LED on the front of the Power

Supply.

Provided Connector (male)

Set Screw

Tighten screws

to clamp wires

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

Pas de commentaire

Carrier Access Network Device Axxius 800 Manuel d'utilisateur Page 16