Carrier Access Network Device Axxius 800 Manuel d'utilisateur télécharger pdf (Page 43)

Axxius 800 - Release 2.2 45

Quick Start

Provision a Unit

l Local using CLI, Telnet, Modem or SNMP (Valet)

l Remotely over an in-band DS0

l Remotely over an SNMP network using NetworkValet EMS

Command Line Interface (CLI)

You can access the CLI using either of the following methods:

l RS-232 connected to the DB-9 port.

l Telnet via Ethernet (10Base-T)

l Modem

Setting up a CLI connection

To connect to the CLI via the RS-232 port, set up a connection to a PC serial port

or dumb terminal using Hyperterm, ProComm, or similar terminal emulation

software:

l Set the Port Settings to:

Bits per second: 9600

Data bits: 8

Parity: None

Stop bits: 1

Flow control: None

l Set the Terminal Emulation to: VT100

NOTE: The Default IP address of the Axxius 800 Controller is 10.0.0.10.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 51 52

Pas de commentaire

Carrier Access Network Device Axxius 800 Manuel d'utilisateur Page 43